US models / USD · No active affiliate agreements or commission-earning links.

How long will a battery run your refrigerator?

By Fordham Tucker · Updated · US appliance planning

A refrigerator does not draw its maximum power all day. For runtime, start with energy consumed over time. For startup, make a separate power check.

Find the number with kWh next to it.

The yellow EnergyGuide label reports estimated annual energy use. Use the energy figure, not the annual dollar cost. The FTC explains how the label supports appliance comparisons. It is a standardized estimate, not a measurement of your particular kitchen.

If your label says 600 kWh/year, divide by 365 for daily use: about 1.64 kWh, or 1,644 Wh per day. Divide that daily figure by 24 for about 68.5 W average. That average already includes the modeled on/off cycling; do not multiply it by another duty-cycle percentage.

Add the things that stay on.

In an illustrative plan, a 12 W router and 20 W of lighting add 32 W. Together with that fridge, the average load becomes 100.5 W. These are example loads, not a claim about your equipment. A modem or fiber terminal may also need power. Powering your own network gear cannot ensure the provider's network stays available.

Account for energy that never reaches the appliance.

Our tool treats the usable battery share, inverter efficiency and battery-side idle overhead separately. With a full battery, a 10% reserve leaves 90% of nominal capacity. A 90% efficiency assumption and 10 W idle draw put battery demand at 100.5 ÷ 0.90 + 10 = about 121.7 W.

The worked example

2,042 Wh × 0.90 ÷ 121.7 W = approximately 15.1 hours.
A 24-hour target needs about 3.24 kWh nominal under exactly these assumptions.

Neither result is a tested runtime. Replace the assumptions with measured or documented values for your equipment.

Compare 12, 24 and 48 hours without changing the assumptions

This is the same illustrative 600 kWh/year refrigerator plus 32 W of continuously used extras: approximately 100.5 W average AC demand, 90% usable battery share, 90% conversion efficiency and 10 W battery-side idle draw. No recharge is included.

Calculated nominal capacity for one declared example load
Outage targetBase demand20% higher average demand
12 hours1.62 kWh1.92 kWh
24 hours3.24 kWh3.84 kWh
48 hours6.49 kWh7.68 kWh

The higher-demand column is a chosen sensitivity scenario, not a measured upper bound. Heat, door openings or different equipment may exceed it. These energy totals do not prove an inverter can start the refrigerator.

Base-demand runtime for hypothetical capacity classes
Nominal capacityCalculated runtime
1 kWh7.4 hours
2 kWh14.8 hours
4 kWh29.6 hours

A 2 kWh class battery does not reach 24 hours in this example. More wattage on the inverter label does not fix that energy gap. Reduce optional loads, make a credible recharge plan, or reconsider the required duration before buying. For small loads, inverter idle draw can change the answer substantially.

If your own sizing points to a 2 kWh model, use the Jackery 2000 v2 and BLUETTI Elite 200 V2 comparison to check the differences before choosing.

Measure before buying bigger.

A suitable plug-in energy meter can capture energy over a representative day, including compressor rest periods and defrost cycles. Use measured daily kWh × 365 as the annual input. Consider a hot day and normal door openings, not just an empty fridge in a cool room. A short instantaneous reading can miss the behavior that matters most.

The nameplate's maximum running watts still matter for inverter capacity. Starting demand, outlet limits and the station's AC timeout settings are separate questions. The startup checklist walks through them. A runtime calculation cannot establish that stored food remains at a safe temperature.

For two separate cold-storage appliances, plan a refrigerator and chest freezer on one battery. Add their normalized energy use without treating either average as its starting demand.

What changes the answer most?

ChangeWhat to expect
Double average appliance loadRuntime drops substantially, but not exactly in half because fixed overhead remains.
Double nominal capacityModeled runtime doubles if every other assumption stays the same.
Start at 60% instead of fullWith a 10% reserve, use 50% as the usable share.
Add solar panelsNot included here; model the uncertain recharge separately.

Put your own numbers to work.

The free calculator turns your annual fridge energy and other loads into a battery estimate, with every assumption visible.

Open the runtime tool ↗